Amano CP-5000 Operations Manual download pdf (Page 54)

6-8 CP-5000 User’s Guide

Hour Change

If the time displayed is off by an hour (either up or down), one of the

following may have occurred:

• The programmed DST settings are incorrect.

• The Enter or Change key was inadvertently pressed.

Card Feed Problems

Card Refused

• Check whether the column of your time card is already completely

filled with imprints. If all positions are already occupied by an imprint,

two beeps will sound, and the card will be rejected without making an

imprint.

• Check the condition of the time card. If there is dirt, oil, dust, or ink

residue on the card, the time card sensors cannot read the Column

Position Block.

• Verify the imprint position. If the Column Position Block is

positioned on artwork or a column line, the time card sensor will read

this as a column full condition.

• A non-Amano ribbon was used. Always use Amano approved

ribbons, non-Amano ribbons bind in the printer carriage, and produce

weak quality prints, and ink residue on print head, rollers, and time

card.

• The background color of your time card is too dark

Card Cannot Enter or Card Blocked

When you insert a time card into the card throat, the feed motor will

grasp it and pull it down to be printed. The feed motor will attempt to

grasp the card a maximum of three times. If the third attempt fails, a

long beep will sound, the feed motor will shut off, and the card must be

manually removed from the card throat.

If a card is blocked or stuck inside the card throat after the imprint has

been printed, the feed motor will attempt to flush out the card a maximum

of three times. If the card is still inside the card throat after the third

attempt, the feed motor will shut down, leaving the card inside the unit. If

the card was unable to be flushed out by the feed motor, it must be

manually removed.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

No comments

Amano CP-5000 Operations Manual Page 54