Amano CP-5000 Operations Manual download pdf (Page 14)

2-6 CP-5000 User’s Guide

External Signal Connections

The CP-5000 is equipped with a single external signal relay circuit that

enables you to activate an audible device such as a bell or buzzer. The

relay contacts of the circuit are Normally Open and should not exceed

Class 2 Circuit requirements (24 VDC at 1A). The duration (in seconds)

that the relay contacts will be activated or closed is set in the Signal

Duration menu item, and the time of the day and day of the week that

this will occur on is set in the Weekly Programming menu.

The wiring schematic for the external signal relay circuit is as follows:

Note: This procedure must be performed with power to both the

external device and the CP-5000 disconnected.

To connect a device to the relay signal circuit, perform the following

steps:

1. Make sure that power to both the external device and the CP-5000

are disconnected.

2. Following the manufacturer’s guidelines for the external device,

connect the signal wires to it and run them to the mounting location

of the CP-5000. Make sure the wires are properly labeled.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

No comments

Amano CP-5000 Operations Manual Page 14