Amano CP-5000 Operations Manual download pdf (Page 28)

4-6 CP-5000 User’s Guide

Basic Programming

Programming Password (Menu 3)

Note: As supplied, the CP-5000 is configured with the default password

“0000”. Whenever a user removes the top cover to enter

programming mode, the clock will request a password by

displaying 0000. If no password has been configured by the

operator, then pressing Enter to accept the default and enter

programming mode. If security regarding clock settings is

important, it is recommended to configure a password other than

the default “0000” setting.

If a password has been programmed, it must be correctly entered in

order to modify any of the clock’s settings. Proceed as follows:

1. Remove the top cover. The display will show four

zeros, the first two of which will be flashing.

2. All passwords contain 4 digits. Using the Change

key, enter the first two digits of the password.

3. Select Enter. The last two digits will flash. Enter

the last two digits of the password.

4. Upon correct entry, the currently set month and

year will display as seen in the next section.

Note: If no password has been programmed, simply press Enter at the

four zero prompt.

Year, Month, and Date (Menu 1, Items 1 & 2)

Note: To set the year, month, and date, you must cycle through the

following sequence of displays for both items and save the data

entered. The data entered will not be saved if you exit the Program

Mode or press the Function key before completing each step.

1. Remove the top cover and enter the previously set password as

explained in the prior section. Upon correct password entry, the Year

menu item will flash in the display.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

No comments

Amano CP-5000 Operations Manual Page 28