Amano PIX-75 Installation Manual download pdf (Page 23)

PIX-75 www.amano.com/time • 1-800-253-9836 2-5

6. From either Line – 1 or Line – 2, press the ENTER

button once to begin programming that line. Note – if

line 1 is not programmed, it must be programmed

before line 2 can be programmed. Line 2 does not have

to be programmed. The 2

line [auxiliary display line]

will flash each symbol item (see right-hand Figure).

7. Press the + or – button until the desired symbol item is

displayed and press the ENTER button once to accept

the flashing symbol value. Once a symbol item has been

selected the number of symbols shown on the right will

increment by one (1). See right-hand Figure for example

showing MONTH for 02 [second] symbol for Line -1.

Note – You can use the +1 HOUR or +1 MINUTE buttons to

scroll up or down through the custom programmed line to see

what symbols are currently chosen for the line.

8. Repeat the process described in step 7 to enter each element for line 1.

Select the “

END” symbol followed by pressing the ENTER button once

to complete custom programming of line 1.

9. If desired, press the + button once to advance to

Line – 2 for custom programming (see right-hand

Figure).

10. Press the ENTER button again to begin symbol

programming for line 2 and follow the same procedure as described in

steps 7 and 8. The first symbol to appear will be the

“END” symbol (see right-hand Figure).

11. Press the

PROGRAM button to end custom print line

symbol programming and/or replace the cover for normal

operation.

To delete a Whole Line of Symbol Printing

1. Press the ENTER button once from the P501 submenu

for custom print and the clock will display

Line – 1 and

the number of programmed symbols (see right-hand Figure

for example of line-1 with 5 symbols).

2. If desired, press the + button once to advance to Line – 2.

3. Press the

ENTER button once and use the + or – buttons to navigate to

the “END” symbol. With this symbol flashing on the Auxiliary Display

Line, press the ENTER button once to save the “END” symbol at the

beginning of the symbol line. This will terminate/delete that line of

symbol printing.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 57 58

Comments to this Manuals

No comments

Amano PIX-75 Installation Manual Page 23

Comments to this Manuals