Amano PIX-75 Installation Manual download pdf (Page 12)

1-12 www.amano.com/time • 1-800-253-9836 PIX-75

Voice Programming Print Format Example

The following table lists the typical pattern of announcement messages that

the clock might play for changing print format.

Voice Message Prompt Reason

“Welcome to the Amano time Clock”

“What would you like to change?”

To greet the user and prompt

for command.

The User says “Print Format” Request the clock to change

the print format.

“The current print format is” followed

by “Please tell me the new print

format” followed by a BEEP.

To announce the current print

format, request the new print

format and prompt with BEEP.

The User says “Format Three” Request the clock to set the

print format = Format 3.

“The new print format is format

three” followed by

“What would you like to change?”

To announce the new print

format set by the user and

inquire for the next possible

change.

The User says “Exit” Request the clock to quit the

voice programming mode.

“Good Bye” To acknowledge exit.

During a typical voice command, the clock might say;

• “Sorry, Command not recognized” To inform the user that it could not

understand the command so the user can repeat the command again.

• “Sorry, data not recognized” To inform the user that it could not

understand the verbal value from the user for the current setting so the

user can repeat the value again.

Voice Programming Hints

• Wait for the clock to complete any voice prompt question followed by a

BEEP before speaking a command.

• Speak as clearly as possible towards the clock within 3 – 4 seconds after

the clock announcement, “Please tell me the new……” followed by a

BEEP.

• Say the entire voice command. Do not use partial commands. For

example, say “Print Language”, not just “Language” or “Print”. See

chart for list of valid commands on page 1-5.

• Complete the voice command within the 3- 4 seconds after a clock

announcement. Failure to do so may result in the clock failing to

recognize the command.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

Comments to this Manuals

No comments

Amano PIX-75 Installation Manual Page 12

Comments to this Manuals