Amano PIX-200 Operations Manual download pdf (Page 23)

Amano PIX-200 Operation Manual 3-9

Changing the Print Position

The illustrations to the right show samples of the displays. The shaded area

means that the symbols, numbers or characters are blinking.

You can set the print position in two directions

(the left or right side of the paper). The factory

default is set to imprint on the right side of the

paper.

To change print direction perform the

following:

1. Unlock and remove the cover.

2. Press the (+) and (E) buttons on the top

of the unit at the same time, holding down

for 2 seconds until SEt UP Pro9 appears

on the display. The “▲” on the top of the

display will be blinking.

3. Press the (+) button three times to position

the “▲” under the THU.

4. Press (E) button once to display “Prn Po5n

ri9ht” blinking.

5. Press the (-) or (+) button to change the

display to “LEFt” blinking.

6. Press the (E) button once to confirm the

setting, and return back to the “SEt UP

Pro9” display.

Setting the Print Pattern

The following illustrations show samples of the displays. The shaded area

means that the symbols, numbers or characters are blinking.

In this setup, the Year digit, the print of Hyphen (-) between month and date,

the printing type of Hour, the printing type of Minutes (Refer to page 6-4

“Diagram of Printing Type of Minutes”), the Language, the preprogrammed

comment, the type of Zero and the print of Leading Zero can be set.

△ △ △ ▲ △ △ △

８ＳＥｔ８ＵＰ８

８Ｐｒｏ９８

△ △ △ ▲ △ △ △

Ｐｒｎ８Ｐｏ５ｎ

８ＬＥＦｔ８

△ △ △ ▲ △ △ △

Ｐｒｎ８Ｐｏ５ｎ

８ｒｉ９ｈｔ

Blinking

MON TUE WED THU FRI SAT SUN

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 49 50

No comments

Amano PIX-200 Operations Manual Page 23