Amano PIX-200 Operations Manual download pdf (Page 12)

2-2

Amano PIX-200 Operation Manual

Wall Mounting

To wall mount perform the following:

1. Remove the cover, and remove the

back plate by pressing on the tab

located on the bottom of the unit

towards the rear, and rotating the

bottom of the plate away from the

clock.

2. Using the back plate as a template,

mark the lower mounting hole on the

wall.

3. Mount the plate using a #10 wood

screw (or equivalent).

4. Level the back plate and mark the

location of the two upper mounting

holes. Secure to the wall using #10

wood screws (or equivalent).

5. Feed the cable of the AC power

adapter through one of the holes in the

back plate.

6. Align the clock with the two upper tabs

on the back plate. Tilt the back of the

clock upwards to fully insert the back

plate tabs into the clock. Be careful not

to pinch the power cord with the

bracket.

7. Once the tabs are inserted, tilt the clock

back down and push it against the wall.

The tabs will snap into place.

8. Replace the cover and lock it in place

with keys provided.

Note: Wall mounting should only be performed by authorized Amano dealers.

If the PIX-200 is improperly mounted, it could fall, resulting in damage to

the unit or personal injury. When mounting the PIX-200 on a concrete

wall, or other special wall material, special screws may be required.

Note: The display LED will not light up until the cover has been put back on.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

No comments

Amano PIX-200 Operations Manual Page 12